ASTM C1060框架建筑物外壳内腔绝热设施温度记录检验

ASTM C1060 Standard Practice for Thermographic Inspection of Insulation Installations in Envelope Cavities of Frame Buildings
ASTM C1060 框架建筑物外壳内腔绝热设施温度记录检验
 
Although infrared imaging systems have the potential to determine many factors concerning the thermal performance of a wall, roof, floor, or ceiling, the emphasis in this practice is on determining whether insulation is missing or whether an insulation installation is malfunctioning. Anomalous thermal images from other apparent causes may also be recorded as supplemental information, even though their interpretation may require procedures and techniques not presented in this practice.

1. Scope
1.1 This practice is a guide to the proper use of infrared imaging systems for conducting qualitative thermal inspections of building walls, ceilings, roofs, and floors, framed in wood or metal, that may contain insulation in the spaces between framing members. This procedure allows the detection of cavities where insulation may be inadequate or missing and allows identification of areas with apparently adequate insulation.
1.2 This practice offers reliable means for detecting suspected missing insulation. It also offers the possibility of detecting partial-thickness insulation, improperly installed insulation, or insulation damaged in service. Proof of missing insulation or a malfunctioning envelope requires independent validation. Validation techniques, such as visual inspection or in-situ R-value measurement, are beyond the scope of this practice.
1.3 This practice is limited to frame construction even though thermography can be used on all building types. ,
1.4 Instrumentation and calibration required under a variety of environmental conditions are described. Instrumentation requirements and measurement procedures are considered for inspections from both inside and outside the structure. Each vantage point offers visual access to areas hidden from the other side.
1.5 The values stated in SI units are to be regarded as standard. The inch-pound units given in parentheses are for information only.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. In particular, caution should be taken in the handling of any cryogenic liquids or pressurized gases required for use in this practice. Specific precautionary statements are given in Note 1 and Note 3.

2. Referenced Documents (purchase separately)
ASTM Standards
ASTM C168 Terminology Relating to Thermal Insulation
ASTM E1213 Test Method for Minimum Resolvable Temperature Difference for Thermal Imaging Systems
ISO Standards
ISO6781 :1983 Thermal Insulation--Qualitative detection of Thermal Irregularities in Building Envelopes -- Infrared Method
Index Terms
building envelope; infrared; in-situ; thermal insulation; wall systems; workmanship; Building envelopes; Air leakage testing--building materials/constructions; Emittance; Field testing--thermal insulation; Image analysis; Infrared (IR) analysis; In-situ inspection/analysis; Leak testing--building constructions/materials; MDTD (minimum detectable temperature differences); Nondestructive evaluation (NDE)--nonmetallic materials; Reflectance and reflectivity; Spatial frequency; Surface analysis--building construction materials/insulation; Temperature tests--thermal insulation; Thermal insulating materials; Thermographic inspection; Walls; Wood frame constructions

更多防火阻燃测试认证，请咨询中国防火网
电话：400-666-7290
网址：www.firete.com
邮箱：info@firete.com

...

 來源：防火網　發布時間：12/6/2013 點擊次數：1181